DTC B22E2: Sub Battery Module State of Charge (Overdischarge) [12/2017 - 10/2023]: Procedure

1. Inspect charging system.

   Refer to ON-VEHICLE INSPECTION [12/2017 - 10/2020] , or refer to ON-VEHICLE INSPECTION [10/2020 - 10/2022] , or refer to ON-VEHICLE INSPECTION [10/2022 - 10/2023]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE CHARGING SYSTEM 

Result: 

OK 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Body Electrical > Sub Battery Module > Clear DTCs 

5. Turn the engine switch off and wait for at least 30 seconds.
6. Turn the engine switch on (IG) and turn the Techstream on.
7. Enter the following menus: Body Electrical / Sub Battery Module / Data List / Sub Battery Module State of Charge.

   Body Electrical > Sub Battery Module > Data List 

   Tester Display
   Sub Battery Module State of Charge

8. Start the engine and while idling, perform charging until the "Sub Battery Module State of Charge" reaches at least 20%*.

   HINT: 

   *: Depending on the current charge of the sub-battery, it may take more than 30 minutes for the SOC (State of Charge) to reach 20% or more.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END