DTC B22E6: Sub Battery Module Overcurrent Malfunction (Charge) [12/2017 - 10/2023]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: System Select / Health Check.
5. Read the DTCs.

   Result

   Result	Proceed to
   DTC B22E6 is output	A
   DTC B22E6 and other DTCs are output	B

Result: 

B 

See step  4

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   HINT: 

   If DTC B22E6 remains, turn the backup relay off to clear the DTC.

   Body Electrical > Sub Battery Module > Clear DTCs 

5. Turn the engine switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the Techstream on.
3. Start the engine.
4. Enter the following menus: Body Electrical / Sub Battery Module / Data List / Sub Battery Module Current.

   Body Electrical > Sub Battery Module > Data List 

   Tester Display
   Sub Battery Module Current

5. Read the Data List according to the display on the Techstream.

   Result

   Result	Proceed to
   -100 to 100 A	A
   Except above	B

Result: 

A 

END 

Result: 

B 

INSPECT CHARGING SYSTEM 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   HINT: 

   If DTC B22E6 remains, turn the backup relay off to clear the DTC.

   Body Electrical > Sub Battery Module > Clear DTCs 

5. Turn the engine switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [12/2017 - 10/2023]