Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated) [09/2015 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location). Refer to INITIALIZATION [09/2015 - ] .

Result: 

NEXT 

See step  2

1. Check that each power window moves when the auto up and down function of the multiplex network master switch assembly, power window regulator switch assembly, rear power window regulator switch assembly LH or rear power window regulator switch assembly RH is operated. Refer to OPERATION CHECK [09/2015 - ] .

   OK

   Auto up and down function is normal (applicable location).

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Remove the door window regulator.
   1. for Front Door : Refer to REMOVAL [09/2015 - ]
   2. for Rear Door : Refer to REMOVAL [09/2015 - ]
2. Install the window glass to the door glass run.
   1. for Front Door : Refer to INSTALLATION [09/2015 - ]
   2. for Rear Door : Refer to INSTALLATION [09/2015 - ]
3. Check if the door window regulator operates smoothly.
4. Check that the window glass slides smoothly when sliding it down by hand.
   NOTE:

   Perform initialization again. Refer to INITIALIZATION [09/2015 - ] .

   HINT: 

   Ensure the following:

   • The window glass fits with the glass run without improper contact or deformation.
   • Foreign matter is not caught in the glass run.
   • The glass run is not misaligned.
   • The belt moulding or inner weatherstrip is not caught.
   • The glass is not tilted and does not catch.

   OK

   Door window glass slides smoothly.

   RESULT
   
   

   Result	Proceed to
   OK (Driver door power window)	A
   OK (Front passenger door power window)	B
   OK (Rear door LH power window)	C
   OK (Rear door RH power window)	D
   NG	E

Result: 

A 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

Refer to REMOVAL [09/2015 - ] )

Result: 

B 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

Refer to REMOVAL [09/2015 - ] )

Result: 

C 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

Refer to REMOVAL [09/2015 - ] )

Result: 

D 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

Refer to REMOVAL [09/2015 - ] )

Result: 

E 

FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE)