Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH [09/2015 - ]: Procedure

1. Check for DTCs. Refer to DTC CHECK / CLEAR [09/2015 - ] .
   RESULT:
   
   

   Result	Proceed to
   DTC is not output	A
   B2311 is output	B
   B2312 is output	C
   B2313 is output	D
   LIN communication system DTCs are output	E

Result: 

B 

GO TO DTC B2311 

Refer to DTC B2311: Power Window Motor Malfunction [09/2015 - ] )

Result: 

C 

GO TO DTC B2312 

Refer to DTC B2312: Power Window Switch Malfunction [09/2015 - ] )

Result: 

D 

GO TO DTC B2313 

Refer to DTC B2313: Glass Position Initialization Incomplete [09/2015 - ] )

Result: 

E 

GO TO LIN COMMUNICATION SYSTEM 

Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2015 - ] )

Result: 

A 

See step  2

1. Check that the rear door power window RH moves when the manual up/down function of the power window regulator switch is operated. Refer to OPERATION CHECK [09/2015 - ] .

   OK

   Rear door power window RH moves.

Result: 

NG 

OTHER PROBLEM (GO TO PROBLEM SYMPTOMS TABLE) 

Refer to Rear Power Window RH does not Operate with Rear Power Window Switch RH [09/2015 - ] )

Result: 

OK 

See step  3

1. Use the Data List to check if the power window regulator motor is functioning properly. Refer to DATA LIST / ACTIVE TEST [09/2015 - ] .
   RR-DOOR MOTOR
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   RR Door P/W Auto SW	Rear power window RH auto up/down signal / ON or OFF	ON: Rear power window RH auto up/down switch operated OFF: Rear power window RH switch not operated	-

   OK

   Techstream display changes according to operation of rear power window switch RH.

Result: 

OK 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

Refer to REMOVAL [09/2015 - ] )

Result: 

NG 

See step  4

1. Disconnect the J3 switch connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disconnect the J4 motor connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J3-4 (AUTO) - J4-4 (AUTO)	Always	Below 1 Ω
   J3-4 (AUTO) or J4-4 (AUTO) - Body ground	Always	10 kΩ or higher

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  5

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the rear power window regulator switch RH. Refer to REMOVAL [09/2015 - ] .
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   J3-4 (AUTO) - J3-5 (GND)	Auto up/down operation	Below 1 Ω

Result: 

OK 

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

Refer to REMOVAL [09/2015 - ] )

Result: 

NG 

REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH 

Refer to REMOVAL [09/2015 - ] )