DTC U023A-87: Lost Communication with Image Processing Module "A" Missing Message [08/2019 - ]: Procedure

1. Using the Techstream, check for vehicle stability control system DTCs.

   Chassis > Brake/EPB > Trouble Codes 

   HINT: 

   If DTC U023A-87 and vehicle stability control system DTCs are output, perform troubleshooting for the vehicle stability control system first.

   Result

   Result	Proceed to
   Vehicle stability control system DTCs are not output	A
   Vehicle stability control system DTCs are output	B

Result: 

B 

GO TO VEHICLE STABILITY CONTROL SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

A 

See step  2

HINT: 

When entering Dealer Mode (Signal Check), the skid control ECU communicates with the forward recognition camera to judge whether the vehicle is equipped with the pre-collision system. Therefore, do not exit Dealer Mode (Signal Check) within 5 seconds of entering Dealer Mode (Signal Check).

1. Procedure to enter Dealer Mode (Signal Check)
   1. Turn the engine switch off.
   2. Apply the parking brake.
   3. Check that the shift lever is in P.
   4. Connect the Techstream to the DLC3.
   5. Turn the engine switch on (IG).
   6. Check that the steering wheel is centered.
   7. Turn the Techstream on.
   8. Enter the following menus: Chassis / Brake/EPB / Utility / Signal Check.

      Chassis > Brake/EPB > Utility 

      Tester Display
      Signal Check

      HINT: 

      Do not exit Dealer Mode (Signal Check) within 5 seconds of entering Dealer Mode (Signal Check). If Dealer Mode (Signal Check) is exited within 5 seconds of entering Dealer Mode (Signal Check), DTC U023A-87 may be stored. If DTC U023A-87 is output after exiting Dealer Mode (Signal Check), enter Dealer Mode (Signal Check) again, wait at least 5 seconds, then recheck for DTCs.

2. Confirm the system has entered Dealer Mode (Signal Check).
   1. Confirm that the ABS warning light and slip indicator light indicate the Dealer Mode pattern (blinking at 0.25 second intervals).

      HINT: 

      • If the ABS warning light or slip indicator light remains illuminated or does not illuminate when Dealer Mode (Signal Check) is entered, a component or wire harness may be malfunctioning.
      • When entering Dealer Mode (Signal Check), if the parking brake is engaged, the parking brake indicator light (red) will illuminate, and if the parking brake is not engaged, the parking brake indicator light (red) will blink in the Dealer Mode pattern (blinking at 0.25 seconds intervals).
3. End of Dealer Mode (Signal Check)
   1. Turn the engine switch off.
   2. Disconnect the Techstream.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Clear the DTCs.

   Body Electrical > Pre-Collision System > Clear DTCs 

2. Make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

3. Check for DTCs.

   Body Electrical > Pre-Collision System > Trouble Codes 

   Result

   Result	Proceed to
   DTC U023A-87 is not output	A
   DTC U023A-87 is output	B

Result: 

A 

END 

Result: 

B 

REPLACE FORWARD RECOGNITION CAMERA. Refer to  COMPONENTS [08/2019 - ]