Data List / Active Test [10/2018 - 07/2022]
- DATA LIST NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Chassis / Lane Control / Data List.
- According to the display on the Techstream, read the Data List.
Chassis > Lane Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Total Distance Traveled - - - Cannot be used Total Distance Traveled - Unit - - - Cannot be used LDA Control Lane control system control status Prohibit or Permit Prohibit: Control prohibited
Permit: Control permitted- Turn Switch (Right) Right turn signal switch status OFF or ON ON: Right turn signal switch on
OFF: Right turn signal switch off- Turn Switch (Left) Left turn signal switch status OFF or ON ON: Left turn signal switch on
OFF: Left turn signal switch off- Vehicle Information (2WD/4WD) - - - Cannot be used Vehicle Information (Conv/HV) - - - Cannot be used
- ACTIVE TEST
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Chassis / Lane Control / Active Test.
- According to the display on the Techstream, perform the Active Test.
Chassis > Lane Control > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Meter Buzzer Sounds the meter buzzer Start or Stop Perform this Active Test with the vehicle is stopped and ignition switch to ON.