October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Tire Pressure Sensor: Removal
- When replacing a wheel or tire, tire pressure sensors must be set up in one of the following ways:
- Remove the sensor from the old wheel and install it to the new wheel.
- Keep the same wheel with tire pressure sensor, and replace only the tire.
- Use a new wheel and sensor (the new sensor must be registered after installation).
- Remove wheel. Remove the valve core and cap, and release air from the tire. See Fig 1.
- After ensuring that air is sufficiently released, remove the nut and washer that is used to secure the tire pressure warning valve and transmitter and drop the sensor inside the tire.
NOTE:
Keep the removed cap and valve core.
- After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of the tire remover. See Fig 2.
NOTE:
Be careful not to damage the tire pressure warning valve and transmitter due to interference between the sensor and tire bead.
- Remove the bead on the upper side in the usual operation.
- Remove the tire pressure warning valve and transmitter from the tire, and remove the bead on the lower side as in usual operation.
- Remove and discard the inner grommet from the tire pressure warning valve and transmitter.
NOTE:
The tire pressure warning valve and transmitter is powered by a lithium battery. When disposing, remove battery and dispose of properly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002