Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) [10/2018 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location).

   Refer to INITIALIZATION [10/2018 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Check that each power window moves when the auto up and down functions of the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly are operated.

   Refer to OPERATION CHECK [10/2018 - ]

   OK

   Auto up and down functions are normal (applicable location).

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Remove the power window regulator motor assembly and door window regulator sub-assembly.
2. Install the door glass to the door glass run.
3. Check that the power window regulator motor assembly and door window regulator sub-assembly operate smoothly.
4. Check that the door glass slides smoothly when sliding it up by hand.
   NOTE:

   Make sure to perform initialization again.

   HINT: 

   Ensure the following: 

   • The door glass fits in the door glass run without improper contact or deformation.
   • Foreign matter is not caught in the door glass run.
   • The door glass run is not misaligned.
   • The door glass is not tilted and does not catch on the door glass run.

   OK

   Door glass slides smoothly.

   Result

   Result	Proceed to
   OK (Driver door power window)	A
   OK (Front passenger door power window)	B
   OK (Rear LH door power window)	C
   OK (Rear RH door power window)	D
   NG	E

Result: 

A 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR). Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR FRONT PASSENGER DOOR). Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR). Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

D 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH DOOR). Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

E 

FIT DOOR GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS)