Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) [09/2014 - ]: Procedure

1. Initialize the power window regulator motor (applicable location) (Refer to INITIALIZATION [09/2014 - 10/2015] or refer to INITIALIZATION [10/2015 - ] ).

Result: 

NEXT 

See step  2

1. Check that all door power windows move when the auto up/down function of the multiplex network master switch and power window regulator switch (for rear LH and rear RH sides) is operated (Refer to OPERATION CHECK [09/2014 - 10/2015] or refer to OPERATION CHECK [10/2015 - ] ).

   OK

   Auto up/down function is normal (applicable location).

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Remove the power window regulator motor.
2. Install the window glass to the door glass run.
3. Check if the power window regulator operates smoothly.
4. Check that the window glass slides smoothly when sliding it up by hand.

   OK

   Window glass slides smoothly.

   WARNING:

   Perform initialization again.

   HINT: 

   Make sure that the following conditions are met:

   • The window glass fits with the glass run without improper contact or deformation.
   • Foreign objects are not caught in the glass run.

Result: 

OK 

REPLACE POWER WINDOW REGULATOR MOTOR (APPLICABLE MOTOR) 

(Refer to PROBLEM SYMPTOMS TABLE [09/2014 - 10/2015] or refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] )

Result: 

NG 

INSTALL WINDOW GLASS CORRECTLY (REMOVE FOREIGN OBJECTS CAUSING IMPROPER FIT OR REPLACE PARTS)