LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2020 >> GS 350 Base, AWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Smart Access System (Keyless Start) (Diagnostics) (Introduction) >> SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Start Function) >> DTC Check / Clear [09/2014 - ] >> DTC Check / Clear [09/2014 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check / Clear [09/2014 - ]

NOTE:

When using the Techstream with the engine switch off to troubleshoot: Connect the Techstream to the DLC3 and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.

  1. CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [POWER SOURCE CONTROL]) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.
    5. Check for DTCs.

      HINT: 

      Refer to the Techstream operator's manual for further details.

  2. CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [STARTING CONTROL]) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Starting Control / Trouble Codes.
    5. Check for DTCs.

      HINT: 

      Refer to the Techstream operator's manual for further details.

  3. CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [SMART ACCESS]) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Smart Access / Trouble Codes.
    5. Check for DTCs.

      HINT: 

      Refer to the Techstream operator's manual for further details.

  4. CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [POWER SOURCE CONTROL]) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.
    5. Clear the DTCs by following the directions on the Techstream display.

      HINT: 

      Refer to the Techstream operator's manual for further details.

  5. CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [STARTING CONTROL]) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Starting Control / Trouble Codes.
    5. Clear the DTCs by following the directions on the Techstream display.

      HINT: 

      Refer to the Techstream operator's manual for further details.

  6. CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [SMART ACCESS]) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Smart Access / Trouble Codes.
    5. Clear the DTCs by following the directions on the Techstream display.

      HINT: 

      Refer to the Techstream operator's manual for further details.

scientia non olet · About LEMON Manuals