Installation [04/2013 - 10/2016]: Procedure

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2024 Lexus IS 500, 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 500, and 2023 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL MULTI-DISPLAY ASSEMBLY
INSTALL NO. 1 MULTI-DISPLAY BRACKET
1. Install the No. 1 multi-display bracket with the 2 screws.

INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET

Engage the clamp.
Connect each connector.

Push the multi-display assembly with bracket as shown in the illustration to engage the 4 clips.

Install the multi-display assembly with bracket with the 2 bolts.

INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 13
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 34
INSTALL METER HOOD SUB-ASSEMBLY
Refer to PROCEDURE - Step 31
CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 35
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 36
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015] , or refer to INITIALIZATION [08/2015 - 10/2016]
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)
Refer to PROCEDURE - Step 19 [04/2013 - 06/2014] , or refer to PROCEDURE - Step 19 [06/2014 - 08/2015] , or refer to PROCEDURE - Step 19 [08/2015 - 10/2016]