How To Proceed With Troubleshooting [11/2017 - 01/2023]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result:
NEXT
See step 2
- INSPECT BATTERY VOLTAGE
- Measure the battery voltage.
Standard Voltage
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Measure the battery voltage.
- CHECK CAN COMMUNICATION SYSTEM*
- Using the Techstream, check if the CAN communication system is functioning normally.
HINT:
Refer to CAN Bus Check in CAN Communication System.
Refer to DIAGNOSIS SYSTEM [11/2017 - 03/2019] , or refer to DIAGNOSIS SYSTEM [03/2019 - 09/2020] , or refer to DIAGNOSIS SYSTEM [09/2020 - 01/2023]
OK
CAN communication system is functioning normally.
Result
Proceed to OK NG
Result:
NG
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - 03/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2019 - 01/2023]
Result:
OK
See step 4
- Using the Techstream, check if the CAN communication system is functioning normally.
- CHECK FOR DTCs* (FORWARD RECOGNITION CAMERA SYSTEM)
HINT:
Refer to DTC Check / Clear.
Refer to DTC CHECK / CLEAR [11/2017 - 01/2023]
- Check for DTCs and note any codes that are output.
Chassis > Front Recognition Camera > Trouble Codes
- Clear the DTCs.
Chassis > Front Recognition Camera > Clear DTCs
- Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.
Chassis > Front Recognition Camera > Trouble Codes
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2017 - 03/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [03/2019 - 01/2023]
Result:
A
See step 5
- Check for DTCs and note any codes that are output.
- PROBLEM SYMPTOMS TABLE
HINT:
Refer to Problem Symptoms Table.
Refer to PROBLEM SYMPTOMS TABLE [11/2017 - 01/2023]
Result
Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B Result:
B
See step 7
Result:
A
See step 6
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Terminals of ECU
Refer to TERMINALS OF ECU [11/2017 - 01/2023]
- Data List / Active Test
Refer to DATA LIST / ACTIVE TEST [11/2017 - 01/2023]
Result
Proceed to NEXT
Result:
NEXT
See step 7
- Terminals of ECU
- ADJUST, REPAIR OR REPLACE NOTE:
If the forward recognition camera has been replaced with a new one, it is necessary to perform forward recognition camera adjustment.
Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [11/2017 - 01/2023]
Result
Proceed to NEXT Result:
NEXT
See step 8
- CONFIRMATION TEST
Result
Proceed to NEXT Result:
NEXT
END