Typical Enabling Conditions

P0712: Range check 

1. The monitor will run whenever these DTCs are not present	None
   Battery voltage	8 V or more
   Engine switch	On (IG)
   Starter	Off

P0713: Range check 

1. One of the following conditions is met: Condition (A) or (B)
   CONDITION (A)
   
   

   The monitor will run whenever the following DTCs are not present	P0115, P0117, P0118: ECT (Engine coolant temperature) sensor circuit P00AC, P00AD, P0110, P0112, P0113: IAT (Intake air temperature) sensor circuit
   Engine coolant temperature (ECT) or intake air temperature (IAT) at engine start	-29.375°C (-20.875°F) or less
   Time after engine start	479 seconds or more
   Engine switch	On (IG)
   Starter	Off
   ECT sensor circuit fail (P0115, P0117, P0118) (Pending + MIL)	Not detected
   IAT sensor circuit fail (P00AC, P00AD, P0110, P0112, P0113) (Pending + MIL)	Not detected

   CONDITION (B)
   
   

   The monitor will run whenever the following DTCs are not present	P0115, P0117, P0118: ECT (Engine coolant temperature) sensor circuit P00AC, P00AD, P0110, P0112, P0113: IAT (Intake air temperature) sensor circuit
   Engine coolant temperature (ECT) or intake air temperature (IAT) at engine start	Higher than -29.375°C (-20.875°F)
   Time after engine start	10 seconds or more
   Engine switch	On (IG)
   Starter	Off
   ECT sensor circuit fail (P0115, P0117, P0118) (Pending + MIL)	Not detected
   IAT sensor circuit fail (P00AC, P00AD, P0110, P0112, P0113) (Pending + MIL)	Not detected