How To Proceed With Troubleshooting [08/2015 - 08/2019]: Procedure

Result

Result: 

NEXT 

See step  2

1. Measure the battery voltage with the engine switch off.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, replace or recharge the battery before proceeding.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. w/ Navigation System:

   Refer to the navigation system.

   Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019]

2. w/o Navigation System:

   Refer to the audio and visual system.

   Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019]

   Result

   Result	Proceed to
   Navigation system or Audio and visual system is normal	A
   Navigation system is abnormal (w/ Navigation System)	B
   Audio and visual system is abnormal (w/o Navigation System)	C

Result: 

B 

GO TO NAVIGATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] 

Result: 

C 

GO TO AUDIO AND VISUAL SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] 

Result: 

A 

See step  4

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019]

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] 

Result: 

A 

See step  5

1. Check for DTCs and note any codes that are output.

   Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] 

2. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] 

3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

   Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] 

   NOTE:

   The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.

   System	Proceed to
   Parking Assist Monitor System	Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019]
   Side Monitor System	Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019]

   Result

   Result	Proceed to
   No DTC is output	A
   DTC is output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019]  

Result: 

A 

See step  6

1. Refer to the Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

A 

See step  7

1. Terminals of ECU.

   Refer to TERMINALS OF ECU [08/2015 - 08/2019] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

See step  9

Result

Result: 

NEXT 

END