Test Mode Procedure [01/2017 - ]

HINT: 

When the system enters test mode, "DRS TEST MODE" is displayed on the multi-information display.

1. Activate Test Mode.
   1. Turn the power switch off.
   2. Connect the Techstream to the DLC3.
   3. Turn the power switch on (IG).
   4. Turn the Techstream on.
   5. Enter the following menus: Chassis / DRS / Utility / Check Mode.

      Chassis > DRS > Utility 

      Tester Display
      Check Mode

2. End Test Mode.
   1. Turn the power switch off.
   2. Connect the Techstream to the DLC3.
   3. Turn the power switch on (IG).
   4. Turn the Techstream on.
   5. Switch the system from test mode to normal mode by following the directions on the Techstream screen.