LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2021 >> LS 500 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Blind Spot Monitor System - Diagnostics - Introduction >> Blind Spot Monitor System >> Customize Parameters [12/2017 - 10/2023] >> Customize Parameters [12/2017 - 10/2023]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Parameters [12/2017 - 10/2023]

  1. CUSTOMIZE BLIND SPOT MONITOR SYSTEM 
    1. Customizing with the Techstream
      NOTE:
      • When the customer requests a change in a function, first make sure that the function can be customized.
      • Be sure to make a note of the current settings before customizing.
      • When troubleshooting a function, first make sure that the function is set to the default setting.
      1. Connect the Techstream to the DLC3.
      2. Turn the engine switch on (IG).
      3. Turn the blind spot monitor system on.
      4. Turn the Techstream on.
      5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Customize / Warning.
      6. Select the setting by referring to the table below.

        Warning 

        Tester Display Description Default Setting ECU
        BSM Buzzer Volume Adjust Sets the volume of the RCTA buzzer (blind spot monitor buzzer). Medium 001:Low, 011:Medium, 101:High Blind Spot Monitor Sensor LH
        BSM Mirror Indicator Brightness Sets the brightness of the indicators in the outer rear view mirror assemblies. Bright 001:Dark, 101:Bright Blind Spot Monitor Sensor RH
        RCTA Function Switches the RCTA function on and off. ON 0:ON, 1:OFF Blind Spot Monitor Sensor RH
        BSM Approaching Vehicle Detection Timing Setting Sets the notification timing for vehicles approaching from behind the vehicle. Middle 00:Only Blind Spot, 01:Late, 10:Middle, 11:Early Blind Spot Monitor Sensor RH
    2. Customizing with multi information display
      NOTE:
      • When the customer requests a change in a function, first make sure that the function can be customized.
      • Be sure to make a note of the current settings before customizing.
      • When troubleshooting a function, first make sure that the function is set to the default setting.
      1. Turn the engine switch on (IG).
      2. Turn the blind spot monitor system on.
      3. Enter the following menus: Settings / Vehicle Settings / BSM
      4. Select the setting by referring to the table below.
        BLIND SPOT MONITOR SETTING

        Display Description Default Setting ECU
        Brightness Sets the brightness of the indicators in the outer rear view mirror assemblies. Bright Dark or Bright Blind Spot Monitor Sensor RH
        Sensitivity Sets the notification timing for vehicles approaching from behind the vehicle. Middle Early, Middle, Late or Only Blind Spot Blind Spot Monitor Sensor RH
        Volume Sets the volume of the RCTA buzzer (blind spot monitor buzzer). 2 3, 2 or 1 Blind Spot Monitor Sensor LH
scientia non olet · About LEMON Manuals