Data List / Active Test [10/2023 - ]
WARNING: This page is about a different car, the 2024 Lexus LS 500h. However, it is still accessible from the selected car via links, so may be relevant.
- DATA LIST NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- Connect the GTS to the DLC3.
- Turn the ignition switch to ON.
- Turn the GTS on.
- Enter the following menus: Body Electrical / Central Gateway / Data List.
- Read the Data List.
Body Electrical > Central Gateway > Data List
Tester Display Measurement Item Range Normal Condition Total Distance Traveled Total distance traveled Min.: 0 km (0 mile), Max.: 16777215 km (10425361 mile) - Total Distance Traveled - Unit Total Distance Traveled unit km or mile - IG2 SW/IGR SW Ignition switch ON signal (IGR terminal) OFF or ON OFF: Ignition switch ACC or off
ON: Ignition switch ONIG1 SW/IGP SW Ignition switch ON signal (IGP terminal) OFF or ON OFF: Ignition switch ACC or off
ON: Ignition switch ONACC SW Ignition switch ACC signal (ACC terminal) OFF or ON OFF: Ignition switch off
ON: Ignition switch ACC or ON+B Voltage Auxiliary battery voltage (BATT terminal) Over 8 V or Under 8 V Over 8 V: Auxiliary battery voltage 8 V or higher
Under 8 V: Auxiliary battery voltage below 8 VEthernet 1 Bus Communication Status Ethernet 1 Bus Communication Status OFF or ON ON: Connection
OFF: No connectionEthernet 1 Bus Communication History Ethernet 1 Bus Communication History OFF or ON ON: With communication history
OFF: Without communication history