Installation [09/2014 - ]: Procedure

INSTALL FRONT STEERING CONTROL ECU
1. Install the front steering control ECU with the 2 bolts.
  Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf)
  
  HINT:
  
  Align the positioning boss of the blower assembly with the hole of the front steering control ECU.
2. Connect the 4 connectors to the front steering control ECU.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 18 [09/2014 - 11/2017] , or refer to PROCEDURE - Step 18 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 18 [10/2018 - 11/2019] , or refer to PROCEDURE - Step 18 [11/2019 - 10/2022] , or refer to PROCEDURE - Step 19 [10/2022 - ]
INSTALL FRONT NO. 2 CONSOLE BOX INSERT
Refer to PROCEDURE - Step 6 [09/2014 - 10/2018] , or refer to PROCEDURE - Step 6 [10/2018 - ]
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 10 [09/2014 - 10/2018] , or refer to PROCEDURE - Step 10 [10/2018 - ]
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to INSTALLATION [09/2014 - ]
PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION
Refer to CALIBRATION [09/2014 - 09/2020] , or refer to CALIBRATION [09/2020 - ]