Inspection [09/2014 - 11/2017]: Procedure
- INSPECT CRUISE CONTROL MAIN SWITCH
- w/o Radar Cruise Control System:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Cruise Control Switch)- - Standard Resistance
Tester Connection Condition Specified Condition 1 (ECC) - 3 (CCS) Cruise control switch (ON-OFF button) released 10 kΩ or higher Cruise control switch (ON-OFF button) pushed Below 2.5 Ω +/RES 235 to 245 Ω -/SET 617 to 643 Ω CANCEL 1509 to 1571 Ω If the result is not as specified, replace the cruise control main switch.
- Measure the resistance according to the value(s) in the table below.
- w/ Radar Cruise Control System:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Cruise Control Switch)- - Standard Resistance
Tester Connection Condition Specified Condition 1 (ECC) - 2 (R/N) Cruise control switch (ON/OFF button) not pressed 10 kΩ or higher MODE Below 2.5 Ω 1 (ECC) - 3 (CCS) Cruise control switch (ON/OFF button) not pressed 10 kΩ or higher Cruise control switch (ON/OFF button) pressed Below 2.5 Ω +/RES 235 to 245 Ω -/SET 617 to 643 Ω CANCEL 1509 to 1571 Ω If the result is not as specified, replace the cruise control main switch.
- Measure the resistance according to the value(s) in the table below.
- w/o Radar Cruise Control System: