DTC C1A50: Brake System [11/2017 - 03/2019]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
5. Check for DTCs.

   Chassis > ABS/VSC/TRAC > Trouble Codes 

   Result

   Result	Proceed to
   Vehicle stability control system DTCs are not output	A
   Vehicle stability control system DTCs are output	B

Result: 

B 

GO TO VEHICLE STABILITY CONTROL SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - 03/2019] 

Result: 

A 

See step  2

1. Clear the DTCs.

   Powertrain > Radar Cruise > Clear DTCs 

2. Perform the following to make sure that the DTC detection conditions are met.

   HINT: 

   If the following conditions are not met, the system cannot detect the malfunction.

   1. Turn the engine switch on (IG).
   2. Wait for 1 second or more.
3. Check for DTCs.

   Powertrain > Radar Cruise > Trouble Codes 

   Result

   Result	Proceed to
   DTC C1A50 is not output	A
   DTC C1A50 is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - 03/2019] 

Result: 

B 

REPLACE DRIVING SUPPORT ECU ASSEMBLY. Refer to  COMPONENTS [09/2014 - 01/2023]