Initialization [03/2019 - ]
NOTE:
- The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly LH removal/installation are shown below.
Performed Work or System Condition Necessary Procedures Link Replacement of the headlight ECU sub-assembly LH Synchronize the vehicle information Refer to INITIALIZATION [03/2019 - ] Perform headlight ECU sub-assembly LH initialization Replacement of the rear height control sensor sub-assembly, removal and reinstallation of the rear height control sensor sub-assembly, replacement of the suspension, etc. has been performed. Perform headlight ECU sub-assembly LH initialization - A new headlight ECU sub-assembly LH cannot operate until the vehicle information has been synchronized.
- After replacing the headlight ECU sub-assembly LH, it is necessary to synchronize the vehicle information and perform initialization.
- Even if the headlight ECU sub-assembly RH is replaced with a new one, it is not necessary to synchronize the vehicle information and perform initialization.