Remove & Install or Remove & Replace
WARNING: This page is about the RC F Base, which is a different variant/trim than selected.
DOES NOT include alignment.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both | Includes: R&I Rear Axle Carrier Assembly. | 6.2 | B | |
| One Side | Includes: R&I Rear Axle Carrier Assembly. | 3.3 | B | |
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Each Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: Includes: Inner and Outer. | ||||
| Each Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||
| Combination Procedure: OUTPUT SHAFT SEAL: Remove & Replace: | ||||
| Each | 0.2 | B | ||