Inspection [09/2014 - ]: Procedure
- INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
- Connect 3 dry cell batteries (1.5 V) in series.NOTE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly)*b Low *c Standard Position *d High *e -45° *f 12° *g +45° - - - Connect a positive (+) lead from the batteries to terminal 3 (VCC) and a negative (-) lead to terminal 1 (GND).
- Measure the voltage between terminals 2 (OUT) and 1 (GND) while slowly moving the link up and down.
Standard Voltage
Tester Connection Condition Specified Condition 2 (OUT) - 1 (GND) +45° (High) 4.5 V 2 (OUT) - 1 (GND) 0° (Standard position) 2.25 V 2 (OUT) - 1 (GND) -45° (Low) 0.5 V If the result is not as specified, replace the rear height control sensor sub-assembly.
- Connect 3 dry cell batteries (1.5 V) in series.