Entry Unlock and Unlatch Functions do not Operate Using Emblem Sensor [09/2015 - 08/2019]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Customize Setting / PSD & PBD operation.

   PSD & PBD operation 

   Tester Display	Description	Default	Setting	ECU
   PBD/Emblem Sensor Function	Function that enables/disables the power back door and rear emblem sensor assembly.	PBD ON/Emblem ON	00:PBD OFF/Emblem OFF, 01:PBD ON/Emblem OFF, 10:PBD ON/Emblem ON	Multiplex Network Door ECU

   Result

   Result	Proceed to
   The customize setting is "PBD ON/Emblem ON"	A
   The customize setting is except "PBD ON/Emblem ON"	B

Result: 

B 

PERFORM CUSTOMIZE SETTING. Refer to  CUSTOMIZE PARAMETERS [09/2015 - 08/2019] 

Result: 

A 

See step  2

1. Close the back door and lock all of the doors.
2. While carrying the electrical key transmitter sub-assembly, press the open switch of the back door opener switch assembly and check that the back door unlocks and unlatches.

   Result

   Result	Proceed to
   Back door unlocks and unlatches	A
   Back door unlocks but does not unlatch	B
   Back door does not unlock	C

Result: 

A 

GO TO POWER BACK DOOR SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING). Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - 08/2019] 

Result: 

B 

GO TO POWER BACK DOOR SYSTEM (Power Back Door cannot be Opened Using the Back Door Opener Switch). Refer to  Power Back Door cannot be Opened Using the Back Door Opener Switch [09/2015 - 08/2019] 

Result: 

C 

GO TO OTHER PROBLEM. Refer to  All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate [09/2015 - ]