New Key Registration Warning Message is not Displayed [09/2015 - ]: Procedure

1. Check for DTCs.

   Body Electrical > Smart Access > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2015 - 12/2017]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [12/2017 - ] 

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Main Body > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   FL Door Courtesy SW	Front door LH courtesy light switch signal	ON or OFF	ON: Front door LH open OFF: Front door LH closed	-

   Body Electrical > Main Body > Data List 

   Tester Display
   FL Door Courtesy SW

   Result

   Result	Proceed to
   On the Techstream screen, ON or OFF is displayed accordingly.	A
   On the Techstream screen, ON or OFF is not displayed accordingly.	B

Result: 

B 

GO TO LIGHTING SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ] 

Result: 

A 

See step  3

1. With all of the doors closed, lock the doors using the entry lock function and check that the warning message is displayed on the multi-information display.

   HINT: 

   Warning function (electrical key transmitter sub-assembly is locked inside the vehicle)

   Refer to SYSTEM DESCRIPTION [09/2015 - 08/2019] , or refer to SYSTEM DESCRIPTION [08/2019 - ]

   Result

   Result	Proceed to
   The warning message is displayed on the multi-information display.	A
   The warning message is not displayed on the multi-information display.	B

Result: 

B 

GO TO METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ] 

Result: 

A 

See step  4

1. Clear all of the registered electrical key transmitter sub-assemblies except one and perform registration again.

   Refer to REGISTRATION [09/2015 - 08/2019] , or refer to REGISTRATION [08/2019 - 07/2021] , or refer to REGISTRATION [07/2021 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. With all of the doors closed, lock the doors using the entry lock function.
2. Unlock the doors using the entry unlock function, open the driver door and check that the warning message is displayed on the multi-information display.

   HINT: 

   Warning function (An electrical key transmitter sub-assembly has been registered)

   Refer to SYSTEM DESCRIPTION [09/2015 - 08/2019] , or refer to SYSTEM DESCRIPTION [08/2019 - ]

   Result

   Result	Proceed to
   The warning message is displayed on the multi-information display.	A
   The warning message is not displayed on the multi-information display.	B

Result: 

A 

END (10 DAYS MAY HAVE ELAPSED SINCE AN ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY WAS REGISTERED) 

Result: 

B 

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY). Refer to  REMOVAL [09/2015 - 08/2016]  , or refer to  REMOVAL [08/2016 - 08/2019]  , or refer to  REMOVAL [08/2019 - ]