How To Proceed With Troubleshooting [10/2015 - 08/2016]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result:
NEXT
See step 2
- CUSTOMER PROBLEM ANALYSIS
Result
Proceed to NEXT Result:
NEXT
See step 3
- INSPECT AUXILIARY BATTERY VOLTAGE
- Measure the auxiliary battery voltage with the power switch off.
Standard Voltage
11 to 14 V
If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.
Result
Proceed to NEXT
Result:
NEXT
See step 4
- Measure the auxiliary battery voltage with the power switch off.
- CHECK CAN COMMUNICATION SYSTEM*
- Use the Techstream to check if the CAN communication system is functioning normally.
Refer to DIAGNOSIS SYSTEM [10/2015 - 08/2016]
Result
Result Proceed to CAN communication system DTCs are not output A CAN communication system DTCs are output B
Result:
B
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - 08/2019]
Result:
A
See step 5
- Use the Techstream to check if the CAN communication system is functioning normally.
- PROBLEM SYMPTOM CONFIRMATION
Result
Proceed to NEXT Result:
NEXT
See step 6
- CHECK DTC*
- Check for DTCs.
Refer to DTC CHECK / CLEAR [10/2015 - 08/2016]
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes
Result
Result Proceed to DTCs are output A DTCs are not output (Problem symptom does not occur) B DTCs are not output (Problem symptom occurs) C
Result:
B
See step 8
Result:
C
See step 9
Result:
A
See step 7
- Check for DTCs.
- DIAGNOSTIC TROUBLE CODE CHART
- Refer to Diagnostic Trouble Code Chart.
Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2015 - 08/2016]
Result
Proceed to NEXT
Result:
NEXT
See step 11
- Refer to Diagnostic Trouble Code Chart.
- SYMPTOM SIMULATION
- Refer to Symptom Simulation.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - 08/2016]
Result
Proceed to NEXT
Result:
NEXT
See step 9
- Refer to Symptom Simulation.
- PROBLEM SYMPTOMS TABLE
- Refer to Problem Symptoms Table.
Refer to PROBLEM SYMPTOMS TABLE [10/2015 - 08/2016]
Result
Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B
Result:
B
See step 11
Result:
A
See step 10
- Refer to Problem Symptoms Table.
- OVERALL ANALYSIS AND TROUBLESHOOTING
- Operation Check
Refer to OPERATION CHECK [10/2015 - 08/2016]
- Terminals of ECU
Refer to TERMINALS OF ECU [10/2015 - 08/2016]
- Data List / Active Test
Refer to DATA LIST / ACTIVE TEST [10/2015 - 08/2016]
Result
Proceed to NEXT
Result:
NEXT
See step 11
- Operation Check
- CIRCUIT INSPECTION
Result
Proceed to NEXT Result:
NEXT
See step 12
- IDENTIFICATION OF PROBLEM
Result
Proceed to NEXT Result:
NEXT
See step 13
- REPAIR OR REPLACE
Result
Proceed to NEXT Result:
NEXT
See step 14
- CONFIRMATION TEST
Result
Proceed to NEXT Result:
NEXT
END