Components [12/2017 - ]
WARNING: This page is about a different variant/trim than selected.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| *1 |
FRONT PROPELLER SHAFT ASSEMBLY |
*2 |
CONSTANT VELOCITY UNIVERSAL JOINT WASHER |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) |
 |
Do not apply lubricants |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| *1 |
REAR ENGINE MOUNTING INSULATOR |
*2 |
REAR ENGINE MOUNTING MEMBER |
| *3 |
TRANSFER ASSEMBLY |
*4 |
NO. 2 PARKING RELEASE CABLE BRACKET SUB-ASSEMBLY |
| *5 |
AUTOMATIC TRANSMISSION ASSEMBLY |
- |
- |
 |
N.m (kgf/cm, ft.lbf): Specified torque |
* |
Precoated part |
| • |
Non-reusable part |
- |
- |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| *1 |
NO. 2 TRANSFER CASE PLUG |
*2 |
OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY |
| *3 |
TRANSFER CASE BREATHER PLUG |
*4 |
TRANSFER CASE PLUG |
| *5 |
TRANSFER DRAIN PLUG |
*6 |
TRANSFER FILLER PLUG |
| *7 |
TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL |
*8 |
TRANSFER FILLER PLUG GASKET |
| *9 |
TRANSFER OUTPUT SHAFT COMPANION FLANGE BOLT |
*10 |
O-RING |
| *11 |
TRANSFER DRAIN PLUG GASKET |
*12 |
TRANSFER CASE GASKET |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) |
|
N.m (kgf/cm, ft.lbf): Specified torque |
| • |
Non-reusable part |
 |
MP grease |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| *1 |
DIFFERENTIAL CASE NEEDLE ROLLER BEARING |
*2 |
DRIVE PINION COMPANION FLANGE OIL SEAL |
| *3 |
DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY |
*4 |
NO. 1 DIFFERENTIAL CASE SUB-ASSEMBLY |
| *5 |
NO. 1 DIFFERENTIAL CASE SUB-ASSEMBLY HOLE SNAP RING |
*6 |
NO. 1 TRANSFER THRUST BEARING RACE |
| *7 |
NO. 2 TRANSFER THRUST BEARING RACE |
*8 |
TRANSFER EXTENSION HOUSING |
| *9 |
TRANSFER EXTENSION HOUSING OIL SEAL |
*10 |
TRANSFER OUTPUT SHAFT CYLINDRICAL ROLLER BEARING |
| *11 |
TRANSFER OUTPUT SHAFT SHIM |
*12 |
TRANSFER OUTPUT SHAFT WASHER |
| *13 |
TRANSFER OUTPUT SHAFT NUT |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) |
|
N.m (kgf/cm, ft.lbf): Specified torque |
| • |
Non-reusable part |
|
MP grease |
| * |
Precoated part |
- |
- |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| *1 |
BREATHER OIL DEFLECTOR |
*2 |
REAR TRANSFER CASE |
| *3 |
TRANSFER COUNTER GEAR ASSEMBLY |
*4 |
TRANSFER COUNTER GEAR BEARING |
| *5 |
TRANSFER FRONT DRIVE GEAR ASSEMBLY |
*6 |
TRANSFER FRONT DRIVE GEAR ASSEMBLY CYLINDRICAL ROLLER BEARING |
| *7 |
TRANSFER IDLER GEAR ASSEMBLY |
*8 |
TRANSFER IDLER GEAR BEARING |
| *9 |
TRANSFER INPUT GEAR STOPPER |
*10 |
TRANSFER INPUT GEAR STOPPER SHAFT SNAP RING |
| *11 |
TRANSFER INPUT SHAFT |
*12 |
TRANSFER OIL SEAL RING |
| *13 |
TRANSFER IDLER GEAR SHIM |
*14 |
TRANSFER COUNTER GEAR SHIM |
| *15 |
NO. 3 TRANSFER THRUST BEARING RACE |
*16 |
TRANSFER COUNTER GEAR SHIM |
| *17 |
NO. 3 TRANSFER THRUST BEARING RACE |
- |
- |
|
N.m (kgf/cm, ft.lbf): Specified torque |
• |
Non-reusable part |
| * |
Precoated part |
- |
- |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| *1 |
FORWARD CLUTCH DRUM OIL SEAL RING |
*2 |
NO. 1 TRANSFER OIL STRAINER |
| *3 |
TRANSFER FRONT CASE OIL SEAL |
*4 |
TRANSFER FRONT DRIVE GEAR PIN |
| *5 |
TRANSFER OIL PUMP DRIVE SHAFT |
*6 |
TRANSFER OIL PUMP PLATE SUB-ASSEMBLY |
| *7 |
TRANSFER OIL SEPARATOR |
*8 |
TRANSFER OIL PUMP PLATE PIN |
| *9 |
TRANSFER OIL PUMP DRIVE ROTOR |
*10 |
TRANSFER OIL PUMP DRIVEN ROTOR |
| *11 |
FRONT TRANSFER CASE |
- |
- |
|
N.m (kgf/cm, ft.lbf): Specified torque |
• |
Non-reusable part |
|
MP grease |
- |
- |