| Monitor runs whenever the following DTCs are not stored |
None |
| All of the following conditions are met |
- |
| Battery voltage |
8 V or higher |
| Time after Battery voltage |
0.5 seconds or more |
| Write Inhibit |
permit |
| Time after Write status forbiddance to permit |
0.5 seconds or more |
| Ignition switch |
ON |
| Time after ignition switch is OFF to ON |
0.5 seconds or more |
| Starter |
OFF |
| Time after Starter ON to OFF |
0.5 seconds or more |
| Engine stop and start ECU A/D Processing fail (P060B) (Pending / MIL) |
Not detected |
| Electric Transmission Fluid Pump Range check fail (P0C2D) (Pending / MIL) |
Not detected |
| Electric Transmission Fluid Pump Performance fail (P2797) (Pending / MIL) |
Not detected |
| Command to Electric Transmission Fluid Pump power supply relay |
ON |
| Output duty cycle |
43% or more, and 100% or less |
| Command to Electric Transmission Fluid Pump ON |
2.5 seconds or more |