DTC P0606-29: Backup Boost Converter "A" Control CPU Signal Invalid [12/2021 - 10/2023]: Procedure

Pre-procedure1

1. Disconnect the engine stop and start ECU connector.

   Procedure1

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   B37-1 (BIN2) - Body ground	Always	9.5 to 14 V
   B37-3 (BIN1) - Body ground	Always	9.5 to 14 V

   Result

   Proceed to
   OK
   NG

   Post-procedure1

3. None

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

Pre-procedure1

1. Disconnect the engine stop and start ECU connector.

   Procedure1

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   B37-2 (GND2) - Body ground	Always	Below 1 Ω
   B37-8 (GND1) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

   Post-procedure1

3. None

Result: 

OK 

REPLACE ENGINE STOP AND START ECU. Refer to  REMOVAL [12/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR