DTC P1235-13: High Pressure Fuel Pump Circuit Open [12/2021 - ]: Procedure

Refer to ON-VEHICLE INSPECTION [12/2021 - ]

HINT: 

Perform "Inspection After Repair" after replacing the fuel pump assembly (for high pressure side).

Refer to INITIALIZATION [12/2021 - ]

Result

Result: 

NG 

REPLACE FUEL PUMP ASSEMBLY (FOR HIGH PRESSURE SIDE) (FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY). Refer to  REMOVAL [12/2021 - ] 

Result: 

OK 

See step  2

Pre-procedure1

1. Disconnect the ECM connector.
2. Disconnect the fuel pump assembly (for high pressure side) connector.

   Procedure1

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C43-2 (FP+) - C37-11 (FP1+)	Always	Below 1 Ω
   C43-1 (FP-) - C37-10 (FP1-)	Always	Below 1 Ω
   C43-2 (FP+) or C37-11 (FP1+) - Body ground and other terminals	Always	10 kΩ or higher
   C43-1 (FP-) or C37-10 (FP1-) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

   Post-procedure1

4. None

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [12/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR