Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter [09/2014 - 11/2017]: Procedure

1. Disconnect the O140 radio receiver assembly connector.
2. Disconnect the O128 No. 1 stereo jack adapter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Radio Receiver Assembly)
   *b	Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly)

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   O140-2 (US1-) - O128-2 (US1-)	Always	Below 1 Ω
   O140-3 (US1+) - O128-3 (US1+)	Always	Below 1 Ω
   O140-5 (USG1) - O128-5 (USG1)	Always	Below 1 Ω
   O140-2 (US1-) - Body ground	Always	10 kΩ or higher
   O140-3 (US1+) - Body ground	Always	10 kΩ or higher
   O140-5 (USG1) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [09/2014 - 11/2017] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR