DTC B00C2-28: Passenger Seat Occupant Classification Sensor "C" Signal Bias Level Out of Range / Zero Adjustment Failure [12/2023 - ]: Procedure

1. Using the GTS, perform "Occupant Detection Sensor Zero Point Calibration".

   HINT: 

   Refer to INITIALIZATION [12/2023 - ]

   Body Electrical > SRS Airbag > Utility 

   Tester Display
   Occupant Detection Sensor Zero Point Calibration

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Clear the DTCs stored in memory.

   Body Electrical > SRS Airbag > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

Pre-procedure1

1. Turn the ignition switch off.
2. Turn the ignition switch to ON, and wait for at least 60 seconds.

   Procedure1

3. Check for DTCs.

   Body Electrical > SRS Airbag > Trouble Codes 

   Result

   Result	Proceed to
   B00C2-28 is output	A
   B00C2-28 is not output	B

   Post-procedure1

4. None

Result: 

B 

END (NORMAL AFTER PERFORMING ZERO POINT CALIBRATION) 

Result: 

A 

See step  4

1. Turn the ignition switch off.
2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 60 seconds.
3. Replace the front seat adjuster assembly RH with a new one.

   HINT: 

   Refer to DISASSEMBLY [12/2023 - ]

4. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Using the GTS, perform "Occupant Detection Sensor Zero Point Calibration".

   HINT: 

   Refer to INITIALIZATION [12/2023 - ]

   Body Electrical > SRS Airbag > Utility 

   Tester Display
   Occupant Detection Sensor Zero Point Calibration

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END (FRONT SEAT ADJUSTER ASSEMBLY RH WAS DEFECTIVE)