DTC P2067: Fuel Level Sensor "B" Circuit Low; DTC P2068: Fuel Level Sensor "B" Circuit High [07/2020 - ]: Procedure

1. Disconnect the No. 2 fuel sender gauge assembly connector.
2. Disconnect the combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   X32-1 (FV2) - P25-18 (FV)	Always	Below 1 Ω
   X32-3 (FR2) - P25-27 (FR)	Always	Below 1 Ω
   X32-2 (FE2) - P25-28 (FE)	Always	Below 1 Ω
   X32-1 (FV) or P25-18 (FV) - Body ground and other terminals	Always	10 kΩ or higher
   X32-3 (FR) or P25-27 (FR) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Remove the No. 2 fuel sender gauge assembly.

   Refer to REMOVAL [07/2020 - 05/2023] , or refer to REMOVAL [05/2023 - ]

2. Inspect the No. 2 fuel sender gauge assembly.

   Refer to INSPECTION [07/2020 - ]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [07/2020 - ] 

Result: 

NG 

REPLACE FUEL SENDER GAGE ASSEMBLY NO. 2. Refer to  REMOVAL [07/2020 - 05/2023]  , or refer to  REMOVAL [05/2023 - ]