DTC Check / Clear [12/2017 - 10/2023]
- CHECK DTCs
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Enter the following menus: Chassis / EMPS / Trouble Codes.
Chassis > EMPS > Trouble Codes
NOTE:If a malfunction is found, repair it, and then check the DTCs again to make sure that no DTCs are output.
- CLEAR DTCs
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Enter the following menus: Chassis / EMPS / Trouble Codes.
Chassis > EMPS > Clear DTCs
- Select the clear button and clear the DTCs according to the display.
- Turn the engine switch off.