Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [12/2021 - ]: Procedure
- READ VALUE USING GTS (MASTER SWITCH)
- Using the GTS, read the data for the condition when the power window master switch assembly with bezel was operated.
Body Electrical > Master Switch > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver door power window auto switch signal OFF or ON OFF: Driver door power window auto switch not being operated
ON: Driver door power window auto switch being operated- Body Electrical > Master Switch > Data List
Tester Display D Door P/W Auto SW OK
On the GTS screen, ON or OFF is displayed accordingly.
Result
Proceed to OK NG
Result:
NG
REPLACE POWER WINDOW MASTER SWITCH ASSEMBLY WITH BEZEL. Refer to REMOVAL [12/2021 - ]
Result:
OK
See step 2
- Using the GTS, read the data for the condition when the power window master switch assembly with bezel was operated.
- READ VALUE USING GTS (D-DOOR MOTOR)
- Using the GTS, read the data for the condition when the power window master switch assembly with bezel was operated.
Body Electrical > D-Door Motor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver door power window auto switch signal OFF or ON OFF: Driver door power window auto switch not being operated
ON: Driver door power window auto switch being operated- Body Electrical > D-Door Motor > Data List
Tester Display D Door P/W Auto SW OK
On the GTS screen, ON or OFF is displayed accordingly.
Result
Proceed to OK NG
Result:
NG
See step 4
Result:
OK
See step 3
- Using the GTS, read the data for the condition when the power window master switch assembly with bezel was operated.
- PERFORM INITIALIZATION
- Initialize the front power window regulator motor assembly LH.
Refer to INITIALIZATION [12/2021 - ]
OK
Power window system operates normally.
Result
Proceed to OK NG
Result:
OK
END (PROBLEM DUE TO INITIALIZATION FAILURE)
Result:
NG
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH. Refer to REMOVAL [12/2021 - ]
- Initialize the front power window regulator motor assembly LH.
- REPLACE POWER WINDOW MASTER SWITCH ASSEMBLY WITH BEZEL
- Temporarily replace the power window master switch assembly with bezel with a new or normally functioning one.
Refer to REMOVAL [12/2021 - ]
OK
Power window system operates normally.
Result
Proceed to OK NG
Result:
OK
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH. Refer to REMOVAL [12/2021 - ]
Result:
NG
END (POWER WINDOW MASTER SWITCH ASSEMBLY WITH BEZEL WAS DEFECTIVE)
- Temporarily replace the power window master switch assembly with bezel with a new or normally functioning one.