Rear Power Window RH does not Operate with Rear Power Window Switch RH [12/2021 - ]: Procedure
- READ VALUE USING GTS (RR-DOOR MOTOR)
- Using the GTS, read the data for the condition when the rear power window regulator switch assembly RH was operated.
Body Electrical > RR-Door Motor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note RR Door P/W Up SW Rear RH door power window manual up switch signal OFF or ON OFF: Rear RH door power window manual up switch not being operated
ON: Rear RH door power window manual up switch being operated- RR Door P/W Down SW Rear RH door power window manual down switch signal OFF or ON OFF: Rear RH door power window manual down switch not being operated
ON: Rear RH door power window manual down switch being operated- Body Electrical > RR-Door Motor > Data List
Tester Display RR Door P/W Up SW RR Door P/W Down SW OK
On the GTS screen, ON or OFF is displayed accordingly.
Result
Proceed to OK NG
Result:
OK
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH. Refer to REMOVAL [12/2021 - ]
Result:
NG
See step 2
- Using the GTS, read the data for the condition when the rear power window regulator switch assembly RH was operated.
- INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
Refer to INSPECTION [12/2021 - ]
Result
Proceed to OK NG Result:
NG
REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH. Refer to REMOVAL [12/2021 - ]
Result:
OK
See step 3
- CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH)
- Disconnect the O14*1 or O20*2 rear power window regulator switch assembly RH connector.
- *1: w/o Door Closer System
*2: w/ Door Closer System
- *1: w/o Door Closer System
- Disconnect the O4 rear power window regulator motor assembly RH connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
W/O DOOR CLOSER SYSTEMTester Connection Condition Specified Condition O14-2 (UP) - O4-10 (UP) Always Below 1 Ω O14-10 (DOWN) - O4-7 (DOWN) Always Below 1 Ω O14-2 (UP) or O4-10 (UP) - Body ground Always 10 kΩ or higher O14-10 (DOWN) or O4-7 (DOWN) - Body ground Always 10 kΩ or higher W/ DOOR CLOSER SYSTEMTester Connection Condition Specified Condition O20-2 (UP) - O4-10 (UP) Always Below 1 Ω O20-10 (DOWN) - O4-7 (DOWN) Always Below 1 Ω O20-2 (UP) or O4-10 (UP) - Body ground Always 10 kΩ or higher O20-10 (DOWN) or O4-7 (DOWN) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH. Refer to REMOVAL [12/2021 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
- Disconnect the O14*1 or O20*2 rear power window regulator switch assembly RH connector.