Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) [11/2021 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location).

   Refer to REGISTRATION [11/2021 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Check that each power window moves when the auto up and down functions of the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly are operated.

   Refer to OPERATION CHECK [11/2021 - ]

   OK

   Auto up and down functions are normal (applicable location).

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Remove the door window regulator.

   for Front Door: Refer to DISASSEMBLY [11/2021 - ]

   for Rear Door: Refer to DISASSEMBLY [11/2021 - ]

2. Install the door glass to the door glass run.

   for Front Door: Refer to REASSEMBLY [11/2021 - ]

   for Rear Door: Refer to REASSEMBLY [11/2021 - ]

3. Check if the door window regulator operates smoothly.
4. Check that the door glass slides smoothly when sliding it up by hand.
   NOTE:

   Make sure to perform initialization again.

   HINT: 

   Ensure the following: 

   • The door glass fits with the glass run without improper contact or deformation.
   • Foreign matter is not caught in the glass run.
   • The glass run is not misaligned.
   • The belt moulding or roof side rail weatherstrip is not caught.
   • The glass is not tilted and does not catch.

   OK

   Door glass slides smoothly.

   Result

   Result	Proceed to
   NG	A
   OK (Driver door power window)	B
   OK (Front passenger door power window)
   OK (Rear LH door power window)	C
   OK (Rear RH door power window)

Result: 

A 

FIT DOOR GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS) 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Door or Front Passenger Door). Refer to  REMOVAL [11/2021 - ] 

Result: 

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door or Rear RH Door). Refer to  REMOVAL [11/2021 - ]