Rear Electronic Module (REM)

REMOVAL
1. Disconnect the battery ground cable. Refer to Battery.

CAUTION:
^ Prior to removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed. For additional information, refer to Module Communications Network (Information Bus).
^ Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.







2. Position the RR quarter trim panel aside.
1 Disconnect the luggage compartment lamp.
2 Remove the push clip.
3 Position RR quarter trim panel aside.







3. Position the Rear Electronic Module (REM) aside.
1 Remove the nuts.
2 Position the REM aside.







4. Remove the REM.
1 Disconnect the seven electrical connectors.
2 Remove the REM.

INSTALLATION
1. To install, reverse the removal procedure.