Mirror Control Switch
Remove mirror control switch. Using an ohmmeter, check for continuity between indicated switch connector terminals when switch is activated as specified. See POWER MIRROR SWITCH CONTINUITY TEST table. See Figure . If resistances are not as specified, replace mirror control switch.
POWER MIRROR SWITCH CONTINUITY TEST
| Switch Position | Continuity Between Terminals No. | |
|---|---|---|
| Left Mirror | ||
| Up | 2 & 3; 4 & 7 | |
| Down | 2 & 4; 7 & 8 | |
| Left | 1 & 8; 4 & 7 | |
| Right | 1 & 4; 5 & 7 | |
| Right Mirror | ||
| Up | 3 & 6; 4 & 7 | |
| Down | 4 & 6; 5 & 7 | |
| Left | 4 & 7; 5 & 8 | |
| Right | 4 & 5; 7 & 8 | |