LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 2003 >> Aviator AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1848 (Instrument Cluster) >> Removal And Installation >> Instrument Cluster >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Instrument Cluster: Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

    Zephyr 

  1. Install the instrument cluster.
    • Connect the electrical connector.
    • Install the 2 screws.
  2. Position the instrument cluster finish panel and install the 2 screws.

    3. Fusion, Milan 

    NOTE: Install the bottom portion of the instrument cluster on the instrument panel locator pins and rotate the top of the instrument cluster into position.
  3. Install the instrument cluster.
    • Connect the electrical connector.
    • Install the 2 screws.
  4. Install the instrument cluster finish panel.

    5. All Vehicles 

  5. Repower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  6. Download the instrument cluster configuration information from the diagnostic tool into the new instrument cluster. For additional information, refer to MODULE CONFIGURATION .
    7. NOTE: If a new instrument cluster is installed updated, or re-configured, the instrument cluster and the powertrain control module (PCM) require a parameter reset to allow the instrument cluster and the PCM to recognize each other. Failure to carry out the parameter reset to the instrument cluster and the PCM may result in a no start condition.
    NOTE: The vehicles integrated keys (or standard PATS keys) must be programmed to the new instrument cluster.
  7. Carry out the parameter reset and key programming procedure. For additional information, refer to ANTI-THEFT - PATS .
scientia non olet · About LEMON Manuals