Fender

Fender

Removal and Installation

1. Remove the fender splash shield. For additional information, refer to Fender Splash Shield Fender Splash Shield.

2. Remove the 2 front bumper cover-to-fender bolts.
- To install, tighten to 11 Nm (97 lb-in).

3. Remove the fender-to-radiator support bolt.
- To install, tighten to 12 Nm (106 lb-in).

4. Remove the 2 lower fender bolts.
- To install, tighten to 12 Nm (106 lb-in).

5. Remove the headlamp.
- Remove the 2 headlamp bolts.

- Disconnect the electrical connectors.

6. Remove the cowl panel grille. For additional information, refer to Cowl Panel Grille Service and Repair.

7. Remove the 4 upper fender bolts and remove the fender.
- To install, tighten to 12 Nm (106 lb-in).

8. To install, reverse the removal procedure.