LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 2010 >> Navigator RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1539 (Interior Lighting System) >> Removal And Installation >> Ambient Lighting Module >> Removal and Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal and Installation

WARNING: This page is about a different car, the 2010 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console finish panel.
    • Lift upward on the rear of the floor console finish panel to release the floor console finish panel clips.
    • If equipped, disconnect the electrical connector.
    • Slide the park brake lever boot and the floor console finish panel over the park brake lever.
  2. NOTE: The ambient lighting module is mounted under the bottom of the floor console finish panel cup holder.

    Remove the 2 screws and the ambient lighting module.

    • Disconnect the electrical connector.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals