Seat Control Switch: Installation

All seats 

1. Install the seat control switch in the following sequence.
   1. Position the seat control switch to the cushion side shield.
   2. Position the seat control switch cover and install the screws.
2. Install the cushion side shield in the following sequence.
   1. Return all retaining clips back to the cushion side shield before installing the shield.
   2. Engage the hook retainer behind the cushion frame.
   3. Align and engage the 3 retainers.
   4. Install the screw at the front.
   5. Install the scrivet at the back.
3. From the front of the seat, connect the seat control switch electrical connectors and engage the wire harness retainer.
   Fig 1: Locating Seat Control Switch Electrical Connectors And Wire Harness Retainer

   Courtesy of FORD MOTOR CO.
4. Attach the carpet flap toe-kick in the following sequence.
   1. Attach the J-clip to the cushion frame.
   2. Install the carpet flap toe-kick pin-type retainers into the cushion side shield and recliner cover.
5. Position the seat.
   • Position the driver seat all the way forward and down.
   • Position the passenger seat all the way forward and up.
6. Install the safety belt anchor bolt.
   • Tighten to 48 Nm (35 lb-ft).
   • For passenger seat, connect the BTS electrical connector.
7. Install the cushion side shield cover.

   Passenger seat 

8. If a passenger seat was serviced, carry out the Occupant Classification System (OCS) System Reset. For additional information, refer to the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .