Cruise-Control Module (C-CM): Installation

Bracket 

• 1.
  
  Install the 4 bolts and the C-CM bracket assembly.
  • Tighten the bolts to 8 Nm (71 lb-in).

C-CM or bracket 

• 2.
  
  
  NOTE: If a plastic grommet breaks while the C-CM is being installed, a new grommet should be installed.

  Firmly apply pressure to the C-CM so that it seats completely in the grommets.

• 3.
  
  Once the C-CM is installed, pull the C-CM to confirm that all 3 ball studs are fully seated in the grommets.

• 4.
  
  Connect the C-CM connector.

• 5.
  
  If a new C-CM was installed, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in this procedure). For additional information on configuration, refer to PMI in Module Configuration .

• 6.
  
  Vertically and horizontally align the C-CM. For additional information, refer to Cruise Control Module (C-CM) (with Sensor) Adjustment .

• 7.
  
  Install the front bumper cover. For additional information, refer to Bumpers .