In-Vehicle Temperature Sensor: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Remove the lower steering column cover screws and the lower steering column cover.- Disconnect the electrical connector.
- 2.
Remove the bolts and the steering column reinforcement panel.- To install, tighten to 9 Nm (80 lb-in).
- 3.
Remove the in-vehicle temperature sensor in the following sequence.- 1.
Disconnect the in-vehicle temperature sensor electrical connector.
- 2.
Disconnect the aspirator hose.
- 3.
Detach the in-vehicle temperature sensor from the instrument panel finish panel.
- 1.