Driver Door Module (DDM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1088:83 | LIN Bus "B": Value of Signal Protection Calculation Incorrect | GO to Pinpoint Test C |
| B1088:87 | LIN Bus "B": Missing Message | GO to Pinpoint Test C |
| B1189:29 | Front Window Position Sensor: Signal Invalid | GO to Pinpoint Test C |
| B118A:29 | Rear Window Position Sensor: Signal Invalid | GO to Pinpoint Test F |
| B12C5:71 | Front Window Lifter Motor Up Relay: Actuator Stuck | GO to Pinpoint Test C |
| B12C6:71 | Rear Window Lifter Motor Up Relay: Actuator Stuck | GO to Pinpoint Test F |
| B12C7:71 | Rear Window Lifter Motor Down Relay: Actuator Stuck | GO to Pinpoint Test F |
| B12C8:71 | Front Window Lifter Motor Down Relay: Actuator Stuck | GO to Pinpoint Test C |
| B12E9:23 | Rear Window Local Up/Down Switch: Signal Stuck Low | GO to Pinpoint Test F |
| C1B14:11 | Sensor Supply Voltage A: Circuit Short To Ground | GO to Pinpoint Test C |
| C1B14:15 | Sensor Supply Voltage A: Circuit Short To Battery or Open | GO to Pinpoint Test C |
| U2013:24 | Switch Pack: Signal Stuck High | CLEAR the DTC. TEST the system for normal operation from the driver door window control switch. If any individual switches within the driver door window control switch are inoperative or the DTC returns, INSTALL a new driver door window control switch. REFER to: Driver Door Window Control Switch . |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Locks, Latches and Entry Systems . |