Gearshift Linkage
- Loosen lock nuts "A" and "B" at "T" joint and place selector lever in "N". Move transaxle lever to neutral, fourth detent position away from transaxle.
- Turn lock nut "A" until it comes in contact with "T" joint. Tighten lock nut "B". Move selector lever toward "P" until lever on transaxle begins to move and check amount of movement.
- Move lever toward "D" until lever on transaxle begins to move and check amount of movement. Amount of movement should be equal. If movement toward "P" is greater than movement toward "D", loosen lock nut "B" and tighten lock nut "A" so that movement becomes smaller.
- If movement toward "D" is greater than movement toward "P", loosen lock nut "A" and tighten lock nut "B" so that movement becomes smaller. Shift selector lever from "P" to "1". Ensure that a "click" can be felt in each position and gear corresponds to position plate.
- Ensure that lever can be shifted between "D" and "N" without depressing push button. If lever can be shifted from "D" to "R" without depressing push button, or if push button is loose, adjust selector lever handle.