LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1991 >> 323 Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Removal & Installation >> Carburetor (B2200) >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Carburetor (B2200): Reassembly

  1. To reassemble, reverse disassembly procedure using new gaskets. DO NOT install spring pin in front of mixture screw until idle mixture has been adjusted with engine running. Before installing air horn on main body, adjust float level and float drop; install a new "O" ring on air/fuel solenoid valve and coat "O" ring with gasoline.
  2. After reassembly and before installing carburetor, adjust choke pull-off diaphragm, fast idle cam (throttle opening angle), fast idle cam (choke opening angle), choke unloader, secondary throttle valve and accelerator cable.
  3. After installing carburetor, adjust curb (hot) idle speed, fast (cold) idle speed and idle mixture. See appropriate ADJUSTMENTS article in the ENGINE PERFORMANCE section.
scientia non olet · About LEMON Manuals