September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Throttle Position (TP) Sensor: Adjustment
- Insert a feeler gauge of specified thickness between throttle lever and throttle stop screw. See TP SENSOR ADJUSTMENT table. Check continuity between TP sensor connector terminals "C" and "D". See Fig 1
.
- If continuity is not as specified, loosen TP sensor mounting screws. Rotate TP sensor until continuity is as specified. Tighten mounting screws. Connect TP sensor connector.
TP SENSOR RESISTANCE
| Application |
Ohms |
| Between Terminals "A" & "D" |
3000-6000 |
| Between Terminals "B" & "D" |
| Closed Throttle |
200-600 |
| Wide Open Throttle |
3300-7000 |
TP SENSOR ADJUSTMENT
| Test Condition |
Continuity Between Terminals "C" & "D" |
| .004" (.1 mm) |
Yes |
| .008" (.2 mm) |
No |
Courtesy of MAZDA MOTORS CORP.