Transmission Position Sensor/Switch: Testing and Inspection
INSPECTIONInspection of Operation
1. Verify that the starter operates only with the ignition switch at the START position and the selector lever in P and N positions.
2. Verify that the back-up lights illuminate when shifted to R position with the ignition switch in the ON position.
3. Verify that the positions of the selector lever and the selector indicator light of the instrument cluster are aligned.
4. Check the transaxle range switch if not as specified.
Inspection of Continuity
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh air duct, and air cleaner assembly.
3. Disconnect the transaxle range switch connector.
4. Check continuity of the transaxle range switch.
5. If not as specified, replace or adjust the transaxle range switch.
6. Connect the transaxle range switch connector.
7. Install the resonance chamber, fresh air duct, and air cleaner assembly.
8. Connect the negative battery cable.